Download  Print this page

Philips IntelliVue MX800 IntelliVue MP2 Configuration Manual Page 204

Patient monitor..
Hide thumbs

Advertisement

4 Configuration Settings Appendix
Size This setting can be changed in service mode only. It only affects MX800 Independent Display
Interface and MP90 monitors and lets you set the correct size of the external display. Size refers to the
width of the display measured diagonally from one corner to the opposite corner of the viewable screen.
The available choices depend on the choice made for the setting Display Type and range from
10.4"(210x160mm) to 60"(1330x750mm). It is important to configure the Size correctly to
enable the monitor to calculate the correct sweep speed of measurement waves across the screen.
Example: you are using a 22" LCD display with a horizontal dimension of 490mm, but leave the Size at
the factory default value which is 15", equaling a horizontal dimension of 300mm. An ECG wave with a
wave speed set to 25mm/sec would normally need 19.6 sec to be drawn across a screen that is 490mm
wide. With Size incorrectly set to 15" (300mm), the ECG wave will only need 12 sec. This is 1.6 times
faster than it actually should be, resulting in an effective wave speed of about 41 mm/s.
The Size setting also affects the distance between menu entries in setup menus. If you want to optimize
monitor operation for use with a touchscreen, make sure that both Size and Menu Line Spacing
(see "Configuring User Interface Settings" on page 126) are set correctly.
Configuring Interfaces and Input Device Settings
Interfaces and Input Device settings can be changed in service mode only and allow technical personnel to
MX800
configure the behavior of connected interface boards and input devices. For detailed configuration
MP20-90
implications, please refer to the latest IntelliVue Service Guide.
Only
Hardware Setting: Main Setup -> Hardware -> Interfaces
Factory Defaults
Interface
Remote Device IF
Input Device IF
MIB/RS232
1.Setting available on MX800 and MP90 monitors with multiple main displays only.
204
Driver
Oper.
Mode
C S M
SpeedPoint
x
Mouse/Keyb
x
Keyb/Mouse
x
Mouse/Keyb
x
Keyb/Mouse
x
Touch 1
x
Touch 2
x
GM
x
DtOut1
x
DtOut2
x
Setting
1
Same Display
1
Same Display
1
Same Display
1
Same Display
1
Same Display
1
Same Display
1
Same Display
n/a
n/a
n/a
Hardware Settings

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: