Download  Print this page

Philips IntelliVue MX800 IntelliVue MP2 Configuration Manual Page 201

Patient monitor..
Hide thumbs

Advertisement

Hardware Settings
• Moving Image: the Standby screen shows a black screen with an image moving across the screen,
similar to a screensaver.
• Blank: the Standby screen shows a black screen, the display is not shut off.
• Video Off: the video signal and display are turned off.
Interfaces Interface settings can be changed in service mode only. Supported interface board
configurations are listed in the section "Installation Instructions" of the IntelliVue Service Guide.
Keyboard This setting is available in service mode only and allows technical personnel to select the
language of the keyboard that is connected to the P/S2 interface connector. For detailed configuration
implications, refer to the IntelliVue Service Guide.
Data Export The two Data Export settings let you determine the port speeds (baud rate) for up
to two MIB/RS232 data output ports. Data Export 1 determines the speed of the port labeled
DtOut1, and Data Export 2 determines the speed of the port labeled DtOut2. The two data
output ports can be located on the same or on two separate MIB/RS232 interfaces. For details on assigning
data output ports to the MIB/RS232 ports, refer to "Configuring Interfaces and Input Device Settings" on
page 204.
SRR This setting is available for monitors with a short range radio interface only. Configure SRR to Off,
if you want to switch off the short range radio capabilities of the monitor.
Configuring Multiple Display Settings
Multiple Display settings are available for MX800 and MP90 monitors with multiple main displays only.
MX800
MP90
Hardware Setting: Main Setup -> Hardware -> Multiple Display
only
Factory Defaults
Item Name
Display Layout
Display 1
Display 2
Display 3
Oper. 1 Windows
Oper. 2 Windows
FMS 1 Keys
FMS 2 Keys
GM Keys
Meas Sel.Window
ADT Window
Timer Window
ProtWatch Window
Event Surv. Window
Oper.
MX800,
Mode
MP90
C S M
x
Horizontal
x
Operator 1
x
Operator 1
x
Operator 1
x
Same Display
x
Same Display
x
x
Display 1
x
x
Display 1
x
x
Display 1
x
x
Display 1
x
x
Display 1
x
x
Display 1
x
x
Display 1
x
x
Display 1
4 Configuration Settings Appendix
201

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: