4 Configuration Settings Appendix
This section lists all hardware settings. Just like unique monitor settings and global settings, hardware
settings are set once per monitor and are the same in every Profile. Any changes you make to the hardware
settings configuration are automatically stored, there is no need to save them in an extra step.
Hardware settings must be entered for each monitor individually, they are stored in the monitor, and
cannot be cloned using the IntelliVue Support Tool.
Most hardware settings can be changed in service mode only. For detailed configuration implications on
these settings, please refer to the Service Guide provided on the Documentation DVD shipped with your
Hardware Setting: Main Setup -> Hardware
Data Export 1
Data Export 2
1.Entry available on MX800 or MP90 monitors with multiple main displays only.
2.Entry available on MX800, MP40/50, MP60/70, MP80/90 monitors only.
3.Setting available on monitors with a LAN or MIB/RS232 interface only.
4.Setting available on monitors with a short range radio interface only.
Video Video settings are available in service mode only and allow technical personnel to set the correct
resolution for the connected display(s). For detailed configuration implications, refer to the IntelliVue
Service Guide and "Configuring Video Settings" on page 202.
Standby Image This setting lets you change the presentation of the standby screen. Choices for the
first display are Fixed Image or Moving Image. For the 2nd and 3rd independent display, two
additional choices are available: Blank and Video Off.
• Boot Image: the Standby screen shows the boot image configured under Video settings, see
"Configuring Video Settings" on page 202.
C S M
See see "Configuring Multiple
Display Settings" on page 201
See see "Configuring Video Settings" on
See see "Configuring Interfaces and Input Device Settings" on
MP20 -MP80 MP5
See see "Configuring SRR
Channels" on page 205