Download  Print this page

Philips IntelliVue MX800 IntelliVue MP2 Configuration Manual Page 198

Patient monitor..
Hide thumbs

Advertisement

4 Configuration Settings Appendix
1
To print reports from the second paper tray, select the fourth printer in the list, make sure Port is set
to Remote 2, and Printer Status is set to Enabled.
2
To print reports from the third paper tray, select the fifth printer in the list, make sure Port is set to
Remote 3, and Printer Status is set to Enabled.
3
Configure the other printer settings as required for each paper tray.
Configuring one Locally and One Centrally Connected Printer
This is a typical configuration for a monitor connected to one local and one central printer.
To configure the local printer, in the Setup Printers menu, select the first printer in the list and
1
make sure that Port is set to Local 1. Set Printer Status to Enabled. Change the printer
name if required and configure the correct settings for the locally connected printer as described above.
To configure the central printer, in the Setup Printers menu, select the third printer in the list
2
and make sure that Port is set to Remote 1. Set Printer Status to Enabled. Change the
printer name if required and configure the settings for the centrally connected printer as described
above.
3
Make sure that all other printers in the list are set to Disabled.
Configuring a Monitor to Capture Alarm Events in the Print Database during
Transport
You may want to use this feature on transport monitors which have no recorder.
Under Databases > Database Config, make sure that Print Database is set to Small
1
or Large. Any change must be confirmed to take effect. This will cause the monitor to reboot.
2
Under Alarms > Alarm Recording, select all alarms that should trigger a capture (eg HR Red
Only, PVC Red Only, etc.).
Under Recordings > Setup Recordings, select Alarm, and change the Recorder to
3
Printer. This causes any alarm recording to be sent as a Realtime Report to a connected printer. If
during transport no printer is connected to the monitor, the Realtime Report will be stored in the
print database (if configured appropriately, see next steps)
Under Reports > Setup Reports, select Realtime Rep as the Report.
4
a. Configure the Target Device to either Unspecified (factory default) or Database.
b. Configure the Report Size to either Universal or Unspecified. In both cases, the report will be
printed on a printer which has either US Letter or A4 format.
Under Reports > Setup Printers, select Database as the Printer, and configure the
5
Paper Size to either Letter or A4, depending on your prefered paper format.
Under Reports, select AutoPrint Dbs and set it to the desired behavior. For details, refer to
6
"Other Report Settings Configuration Implications" on page 121.
Store the changes.
7
Printing a Test Report
To verify your printer configuration it is strongly recommended that you print a test report.
To print a test report,
198
Global Settings

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: