Download  Print this page

Philips IntelliVue MX800 IntelliVue MP2 Configuration Manual Page 180

Patient monitor..
Hide thumbs

Advertisement

4 Configuration Settings Appendix
The selection and order of timers as they appear in the Timers menu are stored as Global settings.
Factory Defaults
Item Name
<Timer 1>
<Timer 2>
<Timer 3>
<Timer 4>
Timer Selection and Order Configuration Implications
The maximum number of timers that can be simultaneously displayed on the IntelliVue monitor depends
on your monitor model. The IntelliVue MX800, MP60/70/80/90 can run a maximum of four timers, the
MP40/50 can run three timers, the MP5, MP20/30 two timers. The MP2/X2 does not provide a timer
function.
The selection and order of timers is important when you change a numeric on the Main Screen into a
timer:
• The selection determines which timer labels are actually available to choose from.
• The order determines which timer label is used when you change a numeric into an Any Timer. The
monitor automatically uses the label that is located highest in the Timers window, provided that is not
displayed on the Main Screen yet.
To change the selection and order of timers in the Timers menu,
Select Main Setup -> Timers to open the Timers menu.
1
Select the timer label that you want to change.
2
3
From the pop-up key line, select Setup <Timer X> to open the Setup menu for this timer label.
Select Label and change it to a different label. Notice that the monitor automatically applies the
4
settings preconfigured for this label to the timer.
Configuring Manual Data Entry
MX800
Global Setting: Main Setup -> Enter MeasValues -> Setup Meas.
MP5-90
only
Factory Defaults
Item Name
Labels for General Use
Label
Unit
Color
Interval
180
Oper.
MX800,
MP40 - MP50 MP20 - MP30 MP5, MP5T,
Mode
MP60 - MP90
C M
x
Timer A
x
Timer B
x
Timer C
x
Timer D
not applicable
Oper.
MX800,
Mode
MP5 - MP90
C M
x
T1
o
x
C
x
Green
x
4h
MP5SC
not applicable
MP5SC, MP5#P05
White
Global Settings
MP2
X2
not applicable
not applicable

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: