Download  Print this page

Philips IntelliVue MX800 IntelliVue MP2 Configuration Manual Page 175

Patient monitor..
Hide thumbs

Advertisement

Global Settings
Configuring Ask for New Patient Settings
Global Setting: Main Setup -> Global Settings -> Ask For New Pat
Factory Defaults
Item Name
Power Off
Standby
No Basic Vitals
Ask Paced Mode
Ask for New Patient Configuration Implications
Power Off can be configured to a specific time (1min, 10min, 30min, 1h, 3h, or 8h) or to
Never. If the monitor is switched on, after being switched off for longer than the specified time, it will
ask the user whether a new patient is now being monitored. The user can then select Yes to discharge the
current patient and to begin monitoring a new patient or No to continue monitoring with the current
patient data and settings.
Standby can be configured to a specific time (1min, 10min, 30min, 1h, 3h, or 8h) or to Never. If
monitoring is resumed, after the monitor was in Standby for longer than the specified time, it will ask the
user whether a new patient is now being monitored. The user can then select Yes to discharge the current
patient and to begin monitoring a new patient or No to continue monitoring with the current patient data
and settings.
No Basic Vitals can be configured to a specific time (1min, 10min, 30min, 1h, 3h, or 8h) or
to Never. If no basic vitals (HR, RR, Pulse, SpO
monitor will ask the user whether a new patient is now being monitored. The user can then select Yes to
discharge the current patient and to begin monitoring a new patient or No to continue monitoring with
the current patient data and settings.
Ask Paced Mode can be configured to Yes or No. If you set it to Yes and the clinician selects Yes
when asked whether this is a new patient, the monitor will prompt the clinician to enter the patients paced
mode.
Oper.
MX800,
Mode
MP2 - MP90
C M
MP5T, MP5SC
X2
x
Never
x
Never
x
Never
x
No
4 Configuration Settings Appendix
, NBP) have been measured for the specified time, the
2
175

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: