Download  Print this page

Philips IntelliVue MX800 IntelliVue MP2 Configuration Manual Page 100

Patient monitor..
Hide thumbs

Advertisement

4 Configuration Settings Appendix
INOPRelayLatency / Yel.RelayLatency Use this setting to define how long a yellow alarm
or INOP condition must be active before an alarm is issued on any device connected to the alarm relay.
These settings are valid for all serious INOP conditions/all yellow alarms respectively.
Alarm Text Use this setting to define how alarm messages are presented on the monitor screen:
– Standard: Alarm texts are displayed in text form, for example ** Spo2 LOW
– Extended: Alarm texts are displayed as numeric values, for example, ** Spo2 94 < 96, where
the second number shows the current alarm limit, and the first number shows the maximum amount
by which this limit was exceeded.
NoCentrMonMinVol If your monitor is connected to an IntelliVue Information Center, and the
connection is interrupted, the INOP message No Central Monit. will appear, accompanied by an
INOP tone. To help ensure that this INOP, and any other active alarm, is not overlooked, the INOP and
alarm tones may be configured to have a minimum volume. In this case, INOP and alarm tones will sound
even if the monitor alarm volume is set to zero.
LED Brightness lets you configure the brightness of the alarm lamps. Three choices are available:
High, Medium, and Low.
Alarm Behavior (For Assistance Publique in France only)
To achieve the behavior required by the Assistance Publique in France, you must configure the settings
listed below to the values given in the table:
Item Name
Alarm Source
Alarm Source Selection Disabled
Alarms Off
Pause Al. 5Min
Pause Al. 10Min
Auto Alarms Off
Alarm OffRemind.
Visual Latching
Audible Latching
Alarm Reminder
Alarm Rem. Time
Alarm Low
Keep Blinking
100
French Alarm Behavior
ECG
Disabled, by setting to 1 or 2 or 3 min (not infinite) See "Configuring Alarms" on page 96.
Disabled
Disabled
Enabled
On
Red&Yell
Red&Yell
ReAlarm or On
1 or 2 or 3 min
>= 1
Yes
Monitor Settings
Comment
See "Configuring ECG/Pulse Alarms"
on page 38.

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: