Connecting Power Supply; Direct Power Supply - Bosch AMC2-16IOE Installation Manual

AMC2 Extensions
4.7

Connecting Power Supply

4.7.1

Direct Power Supply

Connect the power supply to the POWER 7-pin pluggable screw
connector. Refer to Connecting Diagrams, page 48 for a
complete diagram.
Figure 4.6: Location of the power supply connector
Connect an external power supply (10 - 30 Vdc) for AMC2-16IOE
at pin 1 (positive) and pin 3 (0 V) of the pluggable screw
connector.
If an uninterruptible power supply (UPS) is used, the relay
output for power good signals from the UPS is connected to the
following pins:
–
–
–
Otherwise these pins must be short-circuited.
Bosch Sicherheitssysteme GmbH
pin 4 and 7 for power good AC
pin 5 and 7 for power good Battery
pin 6 and 7 for power good DC
Installing | en
2016-11 | AMC2-16IOE |
27