Whirlpool WRF954CIHV Use & Care Manual page 10

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Bottom Door Hinge
For your convenience, the refrigerator doors have bottom hinges
with door closers. These closers allow the doors to swing fully
closed with just a gentle push.
IMPORTANT: So that the closers feature will operate properly,
the doors must be removed only when open to a 90° angle to
the front of the cabinet. If 1 or both doors were not at a 90° angle
when removed, the bottom door hinge must be reset.
Reset the Door Hinge
1. Lift the door from the bottom hinge pin, and place it on a
at surface.
® ®
2. Using a TORX T25 screwdriver, remove the bottom hinge
with the bushing from the cabinet.
B
A. Bushing
B. Hinge base
10
3. Insert the bottom hinge and bushing into the corresponding
NOTE: Make sure that the base of the hinge is parallel to the
bottom of the door.
4. Turn the hinge until the hinge base is at a 90° angle to the
90°
A. Hinge base turned to a 90° angle with the bottom edge of the door
5. Remove the hinge from the door. Using a TORX
A
6. The hinge is now reset and prepared for the door to be
slot in the bottom of the door.
A. Hinge base parallel to the bottom edge of the door
bottom edge of the door.
A
90°
screwdriver, reattach the bottom hinge to the refrigerator
cabinet.
replaced. See "Replace Refrigerator Doors" later in
this section.
A
® ®
T25