Roland VXpanded VS-880 Owner's Manual page 49

In INPUT MIX and TRACK MIX, the mixer is placed both before and after the recorder section. A
conceptual diagram showing all the settings in tabular form is given below.
INPUTS
DIGITAL
1 2 3 4 L R
KEY TO KNOBS: Trim
The first stage of the mixer is adjusted by INPUT MIX, and the later stage of the mixer by TRACK
MIX.
However since the VS-880 has the hardware limitation of having only eight channel faders, it is not
possible to adjust both INPUT MIX and TRACK MIX simultaneously. This means that you will
need to switch between INPUT MIX and TRACK MIX during use.
When the mixer and recorder are in one-to-one correspondence
(INPUT TRACK)
In this mode, the channels (1Ð8) of the mixer section correspond respectively to the tracks (1Ð8) of
the recorder section in a one-to-one correspondence.
This is a Òsimple mixer modeÓ that you can use when you want to record a performance in the eas-
iest way. For details refer to ÒMixer section block diagramÓ (p.144).
Recorder
INPUT 1
INPUT 2
INPUT 3
INPUT 4
DIGITAL IN L
DIGITAL IN R
Input select
TRACKS
1 2 3 4 5 6
Pan Level
Track 1 EQ 1
EQ 2
Track 2
EQ 3
Track 3
Track 4 EQ 4
EQ 5
Track 5
Track 6 EQ 6
Track 7 EQ 7
Track 8 EQ 8
Chapter 2 Before you start (VS-880 terminology)
7 8
Input Trim
Mix Out Buss L,R
Aux Out Buss L,R
Effect 1 Insert/Direct Switch
Effect 1 Out Buss L,R
Effect 2 Insert/Direct Switch
Effect 2 Out Buss L,R
EQ On/Off Switch
Hi EQ
Low EQ
Channel Pan
Frequency Boost or Cut
Mixer
Fader 1 Pan 1
Fader 2 Pan 2
Pan 3
Fader 3
Fader 4
Pan 4
Fader 5 Pan 5
Fader 6 Pan 6
Fader 7 Pan 7
Fader 8 Pan 8
Master Outputs
{
Level & Pan
Aux Outputs
{
Level & Pan
Effect 1 Return Switch
Effect 1 Level
Effect 1 Pan
Effect 2 Return Switch
Effect 2 Level
Effect 2 Pan
Master Output Switch
(Master Out,
Aux Send,
Effect 1,
Effect 2)
Master Fader
Selector Switch
MIX buss (MASTER OUT L)
MIX buss (MASTER OUT R)
49