Siemens SIMATIC S5 Manual page 334

PLC Error Messages
Error Con-
Error Message Text
Identi- sec.
fier No
Progr.
250 01
Initialized AI module address
not connected: Programming
error
Additional info. 1:
AI word No.
250 02
Wrong call parameter for
FB ANEI:
BG (module address) not
defined
Additional info. 1:
Module address ("BG")
Additional info. 2:
Channel No. ("KN")
250 03
Wrong call parameter for
FB ANEI:
KN (channel No.) not defined
Additional info. 1:
Module address ("BG")
Additional info. 2:
Channel No. ("KN")
B-74
Possible Cause
Error group No. 12
- User program error
- Module not plugged in
- IM306 defective
- Wrong address set in IM306
- Wrong address used in user
program
Word address of the unconnected
module or AI channel,
decimal display
Error group No. 12
Programming error:
- Module address specified is not
configured
Initial module address,
decimal display
Channel No. used, decimal display
Error group No. 12
Programming error:
- Channel number specified is not
configured
Initial module address,
decimal display
Channel No. used, decimal display
S5-115F Manual
Remedy
- Check user program
- Plug in and configure module
- Replace module
- Replace IM306
- Check addresses set
Warm restart:
1. Stop/Run
- Remove programming error
Warm restart:
1. Stop/Run
- Remove programming error
Warm restart:
1. Stop/Run
EWA 4NEB 811 6149-02