Table of Contents
Advertisement
INSTALLATION
Remove and discard the canti]e;er shelf packing clips
If the floor is not level and it is neecssaD7 to raise the
located just above each shelf" where it books onto the
rear of the cabinet, we suggest rolling the rear wheels
frame. To remove the plastic clips, _iggle the clips
onto apiece ofply_Tood or other sbim material.
sideways and pull straight out.
4. To replace, center the clips in the cut-out areas and
Locating
Your Refrigerator
push in mltil the base grille snaps into place.
1. Allow a free flow of air through the front base grille.
Connecting
the Appliance
2. Yonr model should not be installed where the room
temperature
will go below 55 degrees F., because it
WARNING:
This appliance is designed to operate
will not run freqnently
enough to maintain proper
on a nominal 115 volt, 15 amp, 60 cycle line. There
temperatnre
in the freezer,
should be a separate, grounded circuit serving this
3. For ease of installation, you should leave a space of
appliance only. Do not use an extension cord.
about 1/2 inch between the refrigerator and adjacent
This appliance
is equipped
with
a three-pronged
walls or cabinets. If the refrigerator is placed ruth the
grounding
plug for your protection
against possible
hinge side against a wall, you mav want to leave
electrical
shock hazards. It must be plugged
into a
additional space so the door can be opened x_4der,
grounding reccptacIe. Where a standard two prongwall
(Refer to the installation
instructions
for more
receptacle
is
encountered,
it
is
the
personal
detail.)
responsibility
arid obligation of"the customer to haxe it
Important
Leveling
Information
replaced
with a properly
grounded
three-prnng
wall
Your refrigerator is equipped with front and back rollers
receptacle.
Do not under anv circmnstances,
cut or
remove the third (ground) pro;lg f?om the power cord.
sn it can be moved away from the wall fbr cleaning. The
front rollers are adjustable and should be positioned so
Do not use an adapter plug.
the refrigerator sits firmly on the floor and is level.
To adjust
the front
rollers:
_,_
1. Remove the base grille by grasping file ends, lift and
_
,ull out.
o
Energy Saving Tips
_
_
l. Locate the refrigerator
away f)'ona be'at prodndng
2. To level the refrigeratm; nse a screwdriver and tnrn
appliances
such as the range or dishwasher,
heat
roller adjusting screws cloc!_vise to raise the cabinet
vents and direct sunlight.
or counterclockavise to lower the cabinet.
2. Level the refrigerator
and do not block ventilation
i
around the f?ont grille.
3. Kccp the freezer fidl to near capaci)' so less cold air
will escape during door openings. When less than
two-thirds full, place milk cartons half full of water in
the freezer.
4. Let hot dishes cool slightl;_ before putting into the
refrigerator or freezer.
5. Cover liquids.
6. Clean the refrigerator
condenser coils once a year;
more often if yon have pets (see page 12).
3. It is not necessary- to lock the refrigerator in place.
7. Wipe moisture from the outside of containers before
However, if that is desirable, tuna one or both of the
placing them into the refi'igerator.
locking feet clocl_4se. They are located near the
8. A_oid opening the doors too often.
front wheels.
PAGE 1
Hide quick links:
Advertisement
Table of Contents
