Table of Contents
Advertisement
U
S I N G T H E
The crossover functions are controlled through the use of an
XCard and can be set for high-pass, low-pass or full range
operation. These cards are shipped in the most common fre-
quency. Each crossover card has two faces: one face operates Full
Range, the other has arrows to indicate the edge for selecting HP
(high-pass) or LP (low-pass) operation. Orient the card with the
desired operating edge, indicated by the arrow, toward the socket
terminals inside the amplifier. Firmly, but carefully, plug the card
into the socket.
The crossover point can be altered by changing the resistor value.
Use the following formula to select the appropriate resistor value
to be placed on the XCard.
3386
= R (in k ) for .047 f cap
f o
7234
= R (in k ) for .022 f cap
f o
Where: R =
f o = desired crossover frequency
c = capacitor in farads
ex: .047 x 10 -6 for .047mf cap
XC
ARD
High Pass
LP
HP
Low Pass
HP
LP
The actual formula is:
R =
Crossover Card
High Pass
FULL
Low Pass
Full Range
– 12 –
Full Range
FULL
1
2 f o c
Hide quick links:
Advertisement
Table of Contents
