Table of Contents
Advertisement
o MECHANTSM
ADJUSTMENTS (HEAD pOStTtON ADJUSTMENT)
o Disassembly
1.
Remove the 2 screws of the arm on the cassette
lid ass'y. (Ref. No.4 @, @ on page 4.)
Remove the 3 screws of the bottom cabinet ass'y
and then, take out the bottom cabinet ass'y.
(Ref. No. 1 on page 3.)
Remove the LCD flexible board from the
connector. (JU02)
Remove the 4 screws of the Rear protector
retainer and open the center frame. Pull the
cassette lid ass'y. (Ref. No. 2 @, @, No. 5 O , @
on pages 3 and 4.)
Insert the small (-) screwdriver into a clearance
between the LCD retainer (R) flange and the
cassette holder in the mechanism little by little,
and then remove a pin at the mechanism side
(shown on the right figure).
Remove a pin at the left side as well.
Connect the connecter (JU02) with the LCD
flexible board which is removed on No. 3.
Press the open detecting switch with an adhesive
tape and hold the power "ON".
A tape is loading without any interference with
the cassette lid ass'y.
Perform head position adjustment after
disassembling
the unit to the point shown on the
below.
2 .
3 .
4.
5.
LCD retainer
(R) flange
6.
7.
8.
9.
Ceramic screwdriver
(Head alignment)
(HOZAN D-2981, + No. 0)
Head alignment
adjusting screwdriver
(R220296)
o Name of adjusting screw
Open detect switch
(Press the open detect switch with an adhesive-tape)
@ Head height
adjusting screw (R)
Tape guide (R)
Tape guide (L)
Head height
adjusting
screw (L)
PCS 79 274
- 12 -
Advertisement
Table of Contents
