About Errors And Warnings; Errors And Warnings; Check And Clearing With Configurator Pm7 - Panasonic FP7 User Manual

Errors and Warnings

15.1 About Errors and Warnings

15.1.1 Errors and Warnings
If any operational unconformity occurs in the positioning unit, an error or warning will occur.
When an error or warning occurs, the following operation will be performed.
Errors
Warnings

15.1.2 Check and Clearing with Configurator PM7

It is possible to check and clear data on an axis-by-axis basis by selecting [Online] → [Status
monitor] on the Configurator PM7 programming tool.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com 15-2
Occurs in any abnormal conditions. When a motor is operating, the operation stops.
The motor stopped due to the occurrence of error will not be activated until the error clear is
executed.
Occurs if there is any operational unconformity but not abnormal.
The operation can continue even after the occurrence of warnings, and the motor continues
running if the motor is operating.