Please read this manual carefully and follow the instructions before installing the power supply. The RF-900WPS is an advanced power supply with excellent acoustic and thermal performance and intelligent thermal fan control technology that makes it virtually silent under 60% load. Five +12V rails deliver safer and more reliable output to your system.
(servicing) instructions in the literature accompanying the appliance. Safety regulations The power supply meets safety guidelines and regulations for UL, cUL, and FCC. Important safety instructions • Do not place your system near a radiator or other heat source.
• Do not open the cover on the power supply case. Dangerous voltages are present inside the cover. Your warranty is void if the cover is removed. • Never operate the device with wet or moist hands. • Never place items in the openings or fan of the power supply.
: Make sure that you connect the power supply to local input AC voltage only. Setting the incorrect voltage can damage the power supply and connected equipment and may void your warranty. The RF-900WPS is compatible with 115 VAC and 230 VAC input voltage.
Page 8
Connect the 8-pin (4+4) or 4-pin +12 V power connectors to your motherboard. Connect the Serial ATA (SATA) connectors to the peripheral devices. Connect the peripheral 4-pin power connectors if you are still using an IDE connector for hard drives or an optical drive. Connect the 6-pin +12 V PCIe connector to your PCI Express graphics cards, as needed.
• Make sure that the power cord is plugged correctly into an AC power outlet and into the power supply. • Make sure that the power switch on the power supply is switched to the “I” (on) position. • Make sure that all power connectors are properly connected to all components.
Page 10
Rated wattage Peak wattage Efficiency Standby Output ripple and noise Output protection Over voltage protection Short circuit protection Over current protection Hi-Pot (the power supply is capable of withstanding) Leakage current Grounding resistance Environmental Operating temperature Storage temperature Operating humidity (non-condensing)
Black PS_ON Green Black -12 V Blue +3.3 V Orange Color Orange Yellow Yellow Purple Gray Black Black Black Orange Orange RF-900WPS Voltage +3.3 V +12 DC +12 DC +5 Vsb PWR_ON +5 V +5 V +3.3 V +3.3 V...
Page 12
+12 V connector 8 (4+4)-pin PCI Express connector Color Signal Black Black Black Black Yellow/Black +12 VDC Yellow/Black +12 VDC Yellow/Black +12 VDC Yellow/Black +12 VDC Color Signal Yellow +12 VDC Yellow +12 VDC Yellow +12 VDC Black Black Black...
Floppy drive connector Color Black Black Yellow SATA power connector Color Yellow Black Black Orange Signal +5 VDC +12 VDC Signal +12 VDC +5 VDC +3.3 VDC RF-900WPS...
Peripheral connector Legal notices FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Product is determined to be defective by an authorized Rocketfish repair center or store personnel, Rocketfish will (at its sole option): (1) repair the Product with new or rebuilt parts; or (2) replace the Product at no charge with new or rebuilt comparable products or parts. Products and parts replaced under this warranty become the property of Rocketfish and are not returned to you.