Remington DURABLADE MB060 Use And Care Manual

IMPORTANT SAFETY
When using an electrical appliance, basic precautions should always be
observed, including the following.
READ ALL INSTRUCTIONS BEFORE USING
THIS APPLIANCE.
DANGER
MB040
To reduce the risk of electric shock:
MB060 ■ Do not reach for an appliance that has fallen into water. Unplug it immediately.
■ Do not place or drop into water or other liquid.
■ Do not place or store this appliance where it can fall or be pulled into a tub or sink.
■ Except when charging, always unplug this appliance from the USB port
immediately after using.
■ Unplug this appliance before cleaning it.
WARNING
To reduce the risk of burns, fire, electric shock or injury to persons:
■ This appliance is for household use only.
■ An appliance should never be left unattended when it's plugged in, except when
charging a rechargeable appliance.
■ Close supervision is necessary when this appliance is used by, on, or near
children or persons with special needs or certain disabilities.
Use and Care Guide ■ Use this appliance only for its intended use as described in this manual.
■ Do not use attachments not recommended by Spectrum Brands, Inc.
■ Keep the cord away from heated surfaces.
■ Never operate this appliance if it has a damaged cord or plug, if it is not
Register Your New Product Today!
working properly, if it has been dropped or damaged, or if it has been dropped
into water.
By registering your new Remington ® product, you will receive these important benefits:
Proof of Ownership • Product Protection • Product Registration • Special Offers ■ Never drop or insert any object into any of the appliance's openings.
Register online at: RemingtonProducts.com
■ Do not use outdoors or operate where aerosol (spray) products are being used,
or where oxygen is being administered.
■ Always store this appliance and cord in a moisture-free area. Do not store it in
INSTRUCTIONS
temperatures exceeding 140°F (60°C).
■ Do not use this appliance with a damaged or broken cutter unit, as injury may
occur. Always make sure blades are aligned properly.
■ Always attach plug to appliance, then USB charging cable to USB port. To
disconnect, turn all controls to OFF, then remove USB charging cable from USB
port, then detach USB charging cable from the clipper for storage.
■ Do not use an extension cord or a voltage converter with this appliance.
■ Do not wrap the cord around the appliance.
This groomer is a wet/dry appliance,
the hand-held part of which may be
used in a bath or shower.
SAVE THESE INSTRUCTIONS

Charging

Product Features

Note: It is recommended to fully charge your appliance before
1 6
using for the first time. Please refer to the charge times shown
in this book.
■ Ensure the product is switched off.
2
■ Connect the product to the USB cable and then connect the USB
end of the cable to a powered USB port.
■ Run time from fully charged is up to 60 minutes.
■ Charge time from empty is 4 hours.
Note: To preserve the life of your batteries, let them run out
every 6 months then fully charge.
3

Charge level indicators

7
9
5 8
4
Product Features
1. 39mm Blade 5. LED charging indicator
2. Trimming head 6. Guide combs (1, 2, 4mm)
3. On/Off Switch 7. Guide combs (MB040 only: 6mm)
4. Power port 8. USB charging cable
9. Detail attachment (MB060 only)

How To Use

■ Switch the product on by pressing the On/Off button.
■ Always comb your beard or mustache with a fine comb before you
start trimming.

Attaching and Removing Trimming Head

NOTE: Always ensure the groomer is switched off before changing
any attachments.
■ To remove, rotate the head counter-clockwise until it unlocks and
then lift off groomer.
■ To attach, place the trimming head on top of the groomer and
rotate the head clockwise until it locks into place.

To Trim the Beard

■ Select your desired trimming length comb. If you are trimming for
Charge Level Indicator
the first time start with the maximum trimming length setting.
Charging LED shows solid ■ Turn the unit on.
■ Place the flat top of the fixed comb against the skin.
Full Charge LED will turn off
■ Slowly slide through the hair against the direction of growth. Repeat
from different directions as necessary.
■ If hair builds up in the trimmer comb during the trimming process,
switch the unit off, pull off the comb and brush the hair off.