Mitsubishi Electric FR-A8AR Instruction Manual page 10

800 series plug-in option relay output function

Hide thumbs Also See for FR-A8AR:

Table of Contents

NOTE

• When mounting/removing the plug-in option, hold the sides of the option. Do not press on the parts on the option

circuit board. Stress applied to the parts by pressing, etc. may cause a failure.

• Caution must be applied to mounting screws falling off when removing and mounting the plug-in option.

• Only one option can be used. When multiple options are mounted, priority is given to option connectors 1, 2 and 3 on

the inverter in this order, and options having a lower priority do not function.

• When the inverter cannot recognize that the option unit is mounted due to improper installation, etc., the protective

function (E.1 to E.3) is activated. A different indication will appear according to the mounted position (option connector

1 to 3).

Mounted position

Option connector 1

Option connector 2

Option connector 3

• When removing the plug-in option, remove the two screws on the left and right, then pull it straight out. Pressure

applied to the connector and to the option board may break the option.

INSTALLATION

Fault indication

Table of Contents