Polk Mono MMC5250 Owner's Manual page 9

5. Route the tweeter wire from the crossover through grommets to the tweeter location.
Push the red and black tweeter wires through the holes in the bottom
of the tweeter cup and though the panel.
6. Slip the male fast-on connector on the red tweeter wire onto the female
connector on the red wire from the crossover and the black tweeter wire to
the black wire (Figure 2). Make sure the clear plastic insulators fully cover
the fast-on connectors otherwise you may short the tweeter leads and possibly dam-
age your amplifier.
7. Mount the tweeters by gently pushing them into the surface mount cup. Be
careful not to pinch the wires.
8. Once the tweeter is mounted and connected, swivel the tweeter to fine-tune
the soundstage image of the system. (Figure 3)
Mounting Option #2 - Flush mounting the
MMC Component Tweeter
1. Remove the panel on which you are going to
mount the tweeter and check for proper clearance
behind it. The flush mount kit is 1-3/16 inch
deep. Measure to make sure there is sufficient
depth behind the spot you choose the final loca-
tion.
2. Use the hole that is punched into the cardboard
packing insert as a template to mark the location
and size of the mounting hole.
3. Mark the center of the spot and cut a hole with
the 2-3/16-inch hole-saw attachment for your
power drill. Go slow. Or you can use a razor
knife instead of a drill.
4. Cut the supplied speaker wire in half.
5. Strip 1/8" – 1/4" (3-6 mm) of plastic insulation
from the cut ends of the tweeter wire. Connect
this end of the wire to the tweeter terminals of
the crossover. Connect the red wire to the positive (+) terminal of the crossover
tweeter output and the black wire to the negative (-) tweeter output terminal.
Figure 4
Figure 5
P O L K A U D I O / M O M O D E S I G N
9