Polk Mono MMC5250 Owner's Manual page 10

6. Route the tweeter wire from the crossover through
grommets location to the tweeter location.
7. Assemble cup, clamp, and machine screw loosely.
8. Route the red and black tweeter wires through the holes in the bottom
of the cup.
9. Slip the male fast-on connector on the red tweeter lead wire onto the female
connector on the red wire from the crossover and the black tweeter lead wire
to the black wire (Figure 2 page 8). Make sure the clear plastic insulators fully cover
the fast-on connectors otherwise you may short the tweeter leads and
possibly damage your amplifier.
10. Press the assembly into the 2-3/16" hole until the clamp edge is below the mounting
surface, then tighten the screw. The cup will clamp down to the surface as
the screw is tightened (Figure 4 page 9). In the case of a thick mounting surface,
the legs of the clamp can be bent outward by inserting a screwdriver through the
four rectangular holes in the cup while still mounted (Figure 5 page 9).
11. Snap the tweeter into the mounting cup, being careful not to pinch the wires.
12. Once the tweeter is mounted and connected, swivel the tweeter by applying firm
pressure to the edge of the tweeter module. DO NOT apply pressure to the grille.
13. Connect positive and negative leads to the crossover.
NOTE: To remove the tweeter assembly, place a small screwdriver
into the side slot and pry carefully upwards
Damage to the tweeter from thermal overload will result without the
protection provided by a crossover and will void your warranty.
OUT
0dB
-3dB
-6dB
TWEETER LEVEL
Figure A
Location of Tweeter Level Attenuation and Input Mode Switch.
(Note: Crossover is not weatherproof. Do not install in areas of potential water exposure.)
P O L K / M O M O :
10 10 10
C H A M P I O N S H I P P E R F O R M A N C E
IN
DUAL
SINGLE
INPUT MODE