leaning and Maintenance
When the water supply is bad, check substances like stone or sand in the filter.
If the filter is clogged with dirt, water cannot flow into the washer. Clean the filter regularly.
Cleaning the filter in the inlet valve
Before cleaning the filter in the inlet valve, completely remove the water remaining in the water hose.
Turn off the water tap and put on the power
Select cold & hot water and press
START/PAUSE button. Let the washer operate
for 5 seconds
Switch off the washer and disconnect the power
Cleaning the lint filter
Press and then pull forward
the lint filter from the washing
tub to the arrow direction.
When the lint filter is worn out, etc., contact a LG Service Center for a new one.
Care and Maintenance
Turn inside out and wash it to
Press & Pull
Disconnect water hose, and remove filter from
the inlet valve by hand or with tools. Remove
dirt with a tooth brush and clean in water.
Then insert it back into the water inlet.
Insert it back into same
place and push until click