Download  Print this page

HP Z4 G4 Maintenance And Service Manual Page 77

Hide thumbs

Advertisement

Control panel message
400-Serial Port A Address Conflict Detected
401-Serial Port B Address Conflict Detected
402-Serial Port C Address Conflict Detected
403-Serial Port D Address Conflict Detected
419-Out of Memory Space for Option ROMs
41A-Front USB3 Not Connected
41B-Device in PCI Express Slot Failed To
Initialize
43A-USB Type-C I2C Not Connected
43B-More Than One USB type-C Cards Are
Installed
500–BIOS Recovery
70x-Wireless Mode Not Supported
800-Keyboard Error
Description
Both external and internal serial ports are
assigned to the same resources.
Both external and internal serial ports are
assigned to the same resources.
Both external and internal serial ports are
assigned to the same resources.
Both external and internal serial ports are
assigned to the same resources.
Recently added PCI expansion card contains an
option ROM too large to download during POST.
Front USB cable has been detached or unseated
from system board.
There is an incompatibility or problem with a
PCIe device and the system or PCIe link could
not be configured to a valid bus width or speed.
Cable is required between FIOUI-P (OCUlink) on
I/O panel and OCUlink connector on the system
board.
More than one USB type-C card is installed.
A system BIOS recovery has occurred.
The system has detected a wireless module
installed in the system that is not supported
and has been disabled.
Keyboard failure.
Recommended action
3.
Replace the hard disk drive.
1.
Remove any serial port expansion cards.
2.
Clear CMOS. (See
Password security and
resetting CMOS on page
3.
Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1.
Remove any serial port expansion cards.
2.
Clear CMOS. (See
Password security and
resetting CMOS on page
3.
Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1.
Remove any serial port expansion cards.
2.
Clear CMOS. (See
Password security and
resetting CMOS on page
3.
Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1.
Remove any serial port expansion cards.
2.
Clear CMOS. (See
Password security and
resetting CMOS on page
3.
Reconfigure card resources and/or run
Computer Setup or Windows utilities.
If a PCI expansion card was recently
added, remove it to see if the problem
remains.
Reconnect or replace front USB cable.
Try rebooting the system. If the error reoccurs,
the device may not work with this system
Install cable between I2C on card and USB-C on
the system board.
Remove USB type-C card so only one is
installed.
Not applicable.
Replace with a supported module.
1.
Reconnect keyboard with computer
turned off.
2.
Check connector for bent or missing pins.
3.
Ensure that none of the keys are
depressed.
4.
Replace keyboard.
POST numeric codes and text messages
73.)
73.)
73.)
73.)
69

Advertisement

Table of Contents

   Related Manuals for HP Z4 G4

Comments to this Manuals

Symbols: 0
Latest comments: