Front Io/User Interface (Fioui) Module - HP Z4 G4 Maintenance And Service Manual

Front IO/User Interface (FIOUI) module

Follow these steps to remove the FIOUI module:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Disconnect the I/O front audio cable (1) from the system board.
4. Disconnect the FIOUI module FUI cable (2) from the FIOUI module.
5. Disconnect the FIOUI module USB cable (3) from the FIOUI module.
6. Disconnect the FIOUI module memory card reader cable (4) from the FIOUI module.
7. Disconnect the FIOUI module FIOUI-Premium (OCUlink) cable (5) from the FIOUI module.
8. Release the FIOUI module by lifting up on the drive release bar (1).
9. Press on the FIOUI module rear panel, and then remove the FIOUI module (2).
Reverse this procedure to install the FIOUI module.
18 Chapter 4 Removal and replacement procedures
Preparation for disassembly on page
Access panel on page 17).
15).