Whirlpool WDTA75SAHN User Instructions page 14

Fold-Down Tines
The row of tines on the left-hand
and right-hand sides of the upper,
or in the back of lower rack can
be adjusted to make room for a
variety of dishes.
To adjust the fold-down tines:
1. Grasp the tip of the tine that
is in the tine holder.
2. Gently push the tine out of
the holder.
3. Lay the tines down, toward
the center of the rack.
EZ-2-Lift™ Top Rack Adjuster
You can raise or lower the top rack to fit tall items in either the top
or bottom rack. Adjusters are located on each side of the top rack.
To raise the rack:
Press both rack adjuster
thumb levers and lift the rack
until it is in the Up position
and level.
To lower the rack:
Press both rack adjusters
thumb levers and slide the
rack to its Down position
and level.
NOTE: The top rack must be level.
Easy-to-Remove Third Level Rack (on some models)
If additional space is
needed in the upper
rack, the third level
rack can easily be
removed.
To remove, fully
extend rack until it
stops. Then, open the
track stops on each
side and slide the rack
out to remove.
Low-profile items,
such as serving
utensils and
silverware, may be
loaded on the third
level rack.
14
A. Track stop B. Track
Removable Top Rack
The removable top rack allows you to wash larger items, such
as pots, roasters, and cookie sheets in the bottom rack.
IMPORTANT: Remove dishes prior to removing the top rack
from dishwasher.
To remove the rack:
1. To gain access to the track stops, pull the upper rack forward
about halfway out of the tub.
2. Press on the edge of the ridged area on the track stop while
tipping the track stop toward the center of the dishwasher.
This action releases a small retaining tab that locks the track
stop to the track (see Track stop – left).
NOTE: It is helpful to use 2 hands. Take special note of the
orientation of the track stops.
3. With the retaining tab released, pull the track stop straight
toward the opposite track to remove it.
4. After removing both track stops, gently pull the top rack out
of the tracks by rolling it toward you.
5. Replace the track stops by coming up from under the track
and slipping the lower tab of the track stop into the lower slot
of the track (see Track stop – right) and rotate the track stop
into place. Then press on the edge of the ridged area while
pushing the track stop straight toward the track. This action
locks the retaining tab back into place.
Track stop
6. Test the track stop by pulling it toward the opposite track to
ensure that it is locked in place.
To replace the rack:
1. Gently pull the tracks forward in dishwasher until they stop.
Remove track stops. See steps 1 through 3 above.
2. Place the back wheels on each side of the rack into the track
and roll the rack into the tracks, but do not push the rack all
the way into the tub.
3. Insert front rack wheels on each side of the rack into the track.
4. Slide the rack into the dishwasher.
5. Replace the track stops. See steps 5 and 6 above.
IMPORTANT: Be sure that the track stops are locked in
place and cannot be easily removed. They keep the rack
from coming out of the track.
–
Track stop left
–
right