Table of Contents
Advertisement
INITIALIZATION OF CENTRAL STATION
7.
INITIALIZATION OF CENTRAL STATION
The procedure for initialization of the group setting and the optional setting is as follows.
7.1. CHANGiNG TO SELF CHECK MODE
Depress the "GROUP (
changed to the self check mode. In case that there is a group in operation, the "NO FUNCTION"
is indicated and the central station can not be changed to the self check mode.
After changing to the self check mode, the LCD indication is changed as shown below. Then,
depress the "GROUP(
station is changed to the initializing mode.
NOTE:
In case that the "GROUP (
operation continues.
7.2. INITIALIZATION OF EEPROM
When the central station is changed to the initializing mode, the LCD indication on the central
station is as shown below. In this condition, depress the "RESET" switch, and the flickering "06"
indication is changed to ON and the initialization is performed.
(In case that initialization is not required, depress the "CHECK" switch, the LCD indication is
automatically changed as shown below.)
"06" flickers. Depress "RESET" switch
and "06" is changed to ON.
In case of EEPROM initialization, it
takes approximately 60–90 seconds.
)" and "MODE" switches simultaneously, the central station is
)" and "MODE" switches simultaneously again, and the central
)" and "MODE" switches are not depressed again, the self check
19
To connection check
Hide quick links:
Advertisement
Table of Contents
