Wet/Dry Vac Assembly; Cord Storage - RIDGID WD1250 Operator's Manual

SP6663 12 GALLON.qxd 3/16/07

Wet/Dry Vac Assembly

1. Line up vacuum port in top assembly
with drain cap located on the front of
the drum.
2. Place lid on top of drum with the drum
latches snug against the drum
channel.
3. Be sure lid completely covers the top
of the drum so leakage does not
occur.
4. Push down on top of the drum latch
areas to cause the flexible locking
tabs to hook onto the drum lip of the
channel.
5. Make sure that the locking tabs are
snapped in place to prevent the lid
from coming off. (See inset).
Your new Wet/Dry Vac is ready for use.
Out
Flexible
Locking Tab
Push
Down
Pull Out
Flexible
Locking
Tab
Drum
Channel
8:57 AM Page 6

Cord Storage

Simply, wrap the power cord around the
power head and snap the connector on
the plug to a wrap of the cord.
Cord Wrap
Area
Blower
Port
Power
Cord
Drum
Caster Feet
w/Accessory Storage
Insert Hose
Drum
Insert the push button end of the "Tug-a-
Long" hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
Top
Assembly
hose out of the vac inlet, as shown.
Push
Down
Pull Out
Flexible
Locking
Tab
6
Pull Handle
Caster
Drain
Cap
Release Button