Download  Print this page

Troubleshooting Your System; Unable To Create A New Partition While Installing Windows 2012/2012 R2 Operating System; 0X0000003B Or 0X0000007E Stop Error Occurs On A System While Using A 4K Sector Disks - Dell PowerEdge S130 User Manual

Hide thumbs


Troubleshooting your system

To get help with your Dell PowerEdge RAID Controller (PERC) S130, you can contact your Dell Technical Service representative or
Unable to create a new partition while installing Windows 2012/2012
R2 operating system
Likely Cause:
If you boot the system in the UEFI mode and then try to install Windows 2012/2012 R2 operating system on
a virtual disk that uses 4K native drives, the following error message is displayed: We could not create
a new partition.
Corrective Action:
To resolve this issue:
0x0000003B or 0x0000007E stop error occurs on a system while using
a 4K sector disks
Likely Cause:
When you boot the system after installing Windows 2012 R2 on a 4K native drives, your system stops
functioning and results in a BSOD with the following error message:
system_thread_exception_not_handled (WppRecorder.sys)
Corrective Action:
To resolve this issue:
For more information, see the KB article
In the Where do you want to install Windows? wizard, select the partition created by setup.exe file,
and then click Delete. Repeat this procedure for other partitions created by setup.exe file.
To create a new installation partition, click New, and then continue installing the OS.
NOTE: To avoid this issue, ensure that you use diskpart.exe file to create a partition while installing
the Windows 20012/2012 R2 OS.
Boot to the recovery console.
Start command prompt.
Run the following command:
c:\windows\system32\compact.exe /U c:\windows\system32\drivers\*.sys
Restart the system.
After you boot successfully, disable the NTFS compression system-wide.
Restart the system again.

Hide quick links:



  Related Manuals for Dell PowerEdge S130

This manual is also suitable for:

Perc s130