Figure 1. Cabling the S130 controller
connector on the first AHCI device (J_SATA A)
Disk connectivity for AHCI devices
The S130 controller supports systems with up to two AHCI devices. For systems with two AHCI devices, the first AHCI device
connects the drives from ports 0–3 and the second AHCI device connects the drives from ports 4–7. For systems with one AHCI
device, all the hard drives are connected to the single AHCI device.
NOTE: For PowerEdge R330, R230, T330, and T130 systems, the S130 controller supports only one AHCI device, which
provides connectivity to all the hard drives in the system.
The following table provides information about the disks connectivity to the AHCI devices supported on the thirteenth generation
connector on the second AHCI device (J_SATA B)