Exposure Values; Default Exposure Values - Planmeca Intra User Manual

EXPOSURE VALUES

13 EXPOSURE VALUES
13.1

Default exposure values

36 Planmeca Intra X-ray Unit
When the unit is switched on, the default exposure values
appear on the displays.
These values can be programmed by the user, see
section 14.1 "Programming the default exposure and
density values" on page 39.
NOTE The exposure values are programmed corresponding
the density value 0 (factory preset value). The expo-
sure time values are automatically scaled according
to the density value.
NOTE These values are for speed F films (Kodak Insight).
For the speed E films (Kodak Ektaspeed) select 1 step
longer and for the speed D films 4 steps longer expo-
sure time.
NOTE The following exposure values need 8 mA.
PATIENT
Adult
Child
NOTE The preprogrammed default exposure values are for
the 20 cm (8") cone. When using the 30 cm long cone,
use the exposure values given in the table below.
PATIENT
Adult
Child
NOTE When using the digital sensor change the exposure
values by pressing the MODE key.
PATIENT
Adult
Child
PATIENT
Adult
Child
kV
63 0.080
60 0.064
kV
63 0.160
60 0.120
kV
63 0.050
60 0.040
kV
63 0.160
60 0.125
User's Manual
time
time
time
time