Installing and Connecting the Projection TV
Inserting Batteries into the Remote Control
Carrying Your Projection TV
The box contains your new projection TV, a remote control and two AA
batteries. No peripheral cables are included. If you intend to add additional
equipment to your projection TV, please check the hookup instructions for
your desired setup before you begin. You may need to purchase cables and/
or splitters to complete the hookup properly.
Insert two size AA (R6) batteries (supplied) by matching the + and – on the
batteries to the diagram inside the battery compartment.
Remove the batteries to avoid damage from possible battery leakage
whenever you anticipate that the remote control will not be used for an
Handle the remote control with care. Avoid dropping it, getting it wet, or
placing it in direct sunlight, near a heater, or where the humidity is high.
Your remote control can be programmed to operate most video
equipment. (See "Programming the Remote Control" on page 57.)
Carrying the projection TV requires three (3) or more people.
The projection TV has been equipped with casters for easy movement on a
Please move your projection TV using the casters.