Sony HDR-AS200V Startup Manual page 15

To reduce the risk of fire or electric shock,
1) do not expose .the unit to rain or moisture.
2) do not place objects filled with liquids, such as vases, on the
apparatus.
Observe the following cautions. as there may be a risk of heat
generation, fire or explosion.
*Lithium-ion battery is built into the product
• Charge the product by the design<!ted charging method.
• Do not place the product in or near fire, or put the product in a
microwave.
• Do not leave the product in a car in hot weather.
• Do not store or use the product in a hot and humid place such as in a
sauna bath.
• Do not disassemble, crush or pierce the product.
• Do not expose the product to excessive shock such as dropping from
a high place.
• Do not expose the product to high temperatures above 60
o c
(140 °F).
• Keep the product dry.
Dispose of the product appropriately.
Charge the product by the designated charging method in the
instruction manual.
This equipment complies with FCCIIC radiation exposure limits set forth
for an uncontrolled environment and meets the FCC radio frequency
(RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF)
Exposure rules.
This equipment has very low levels of RF energy that are deemed to
comply without testing of specific absorption ratio (SAR).
RE. C YCLING LITHIUM-ION BATTERIES
Lithium-ion batteries are recyclable.
You can help preserve our environment by returning your
used rechargeable batteries to the collection and
recycling location nearest you.
For more information regarding recycling of rechargeable
batteries, call toll ftee
1-800-822- 8837, or visit http:/ /www.call2recycle.org/
Caution: Do not handle damaged or leaking Lithium-ion
batteries.
If you have any questions about this product, you may call:
Sony Customer Information Center
1-800-222-SONY {7669}
The number below is for the FCC related matters only.
Regulatory Information
Declaration of Conformity
Trade Name: SONY
Model No.: RM-LVR2
Responsible Party: Sony Electronics Inc.
Address : 16530 Via Esprillo, San Diego, CA 92127 U.S.A.
Telephone No.: 858-942-2230
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment must not be co-located or operated in conjunction with
any other antenna or transmitter.
CAUTION
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this
equipment
Note
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, arid can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver ..
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected .
- Consult the dealer or an experienced radio/TV technician for help.
The supplied interface cable must be used with the equipment in order
to comply with the limits for a digital device pursuant to Subpart B of
Part 15 of FCC Rules.
This device complies with Industry Canada's licence-exempt R5Ss.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that
may cause undesired operation of the device.
Notice for the customers in the countries applying EU
Directives
Manufacturer: Sony Corporation, 1-7-1 Kenan Minato-ku Tokyo, 108-0075
~~n .
For EU product compliance: Sony Deutschland GmbH, Hedelfinger
Strasse 61 , 70327 Stuttgart, Germany
(€
Hereby, Sony Corporation, declares that this equipment is in compliance
with the essential requirements and other relevant provisions of
Directive 1999/5/E(. For details, please access the following URL:
http :/ /www.compliance.sony.de/
Notice
If static electricity or electromagnetism ·causes data tran sfer to
discontinue midway (fail), restart the application or disconnect and
connect the communication cable (USB, etc.) again.
This product has been tested and found compliant with the limits set
out in the EMC regulation for using connection cables shorter than 3
meters (9.8 feet).
The electromagnetic fields at the specific frequencies may influence
the picture and sound of this unit
Disposal of waste batteries and electrical and electronic
equipment (applicable iri the European Union and other
European countries with separate collection systems)
This symbol on the product, the battery or on the
packaging indicates that the product and the battery shall
not be treated as household waste. On certain batteries
this symbol might be used in combination with a chemical
symbol. .
The chemical symbols for mercury (Hg) or lead (Pb) are added if the
battery contains more than 0.0005% mercury or 0.004% lead . By
ensuring these products and batteries are disposed of correctly, you
will help prevent potentially negative consequences for the
environment and human health which could otherwise be caused by
inappropriate waste handling. The recycling of the materials will help to
conserve natural resources.
In case of products that for safety, performance or data integrity
reasons require a permanent connection with an incorporated battery,
this battery should be replaced by qualified service staff only. To ensure
that the battery and the electrical and electronic equipment will be
treated properly, hand over these products at end-of-life to the
applicable collection point for the recycling of electrical and electronic
equipment For all other batteries, please view the section on how to
remove the battery from the product safely. Hand the battery over to
the applicable collection point for the recycling of waste batteries. For
more detailed information about recycling of this product or battery,
please contact your local - Civic Office, your household waste disposal
service or the shop where you purchased the product or battery.
r
TRA
REGISTERED No:
ER0098751/12
DEALER No:
DA0073692/11
[Live-View Remote]
Do not use/store the remote control in the following places
• In an extremely hot place
In places such as in a car parked in the sun, the remote control body
may become deformed and this may cause a malfunction.
• In direct sunlight or near a heater
If you store the remote control in direct sunlight or near a heater, the
remote control may become discolored or deformed, and these may
cause a malfunction:
• In a location subject to strong vibration
• Near strong magnetic fields
• In sandy or dusty places
Be careful not to let sand or dust get into the remote control. This may
cause the remote control to malfunction, and in some cases may be
irreparable.
Wi-Fi function
• Use the remote control in accordance with the regulations of the area
of use.
• You cannot use the Wi-Fi function of the remote control underwater.
Security in the use of wireless LAN devices
• To avoid hacking, access by malicious third parties, and other
vulnerabilities, confirm that the wireless LAN is always secure.
• It is very important to set up security on a wireless LAN .
• If a problem occurs due to inadequate security measures or due to
foreseeable circumstances, Sony Corporation is not responsible for
any resulting damage.
On moisture condensation
If the remote control is brought directly from a cold to a warm location,
moisture may condense inside or outside the remote control. This
moisture condensation may cause a malfunction of the remote control.
If moisture condensation occurs
Turn off the remote control and wait about an hour for the moisture to
evaporate.
Operating temperature
• The remote control is designed for use in temperatures between -10
o c
and +40
· o c
(14 °F and 104 °F). Using in extremely cold or hot places
outside this range is not recommended.
• The LCD screen and the cabinet become warm during operation. This
is not a malfunction .
Handling the LCD screen
• Do n_ o t leave the LCD screen facing the sun as it may be damaged. Be
careful when placing the remote control by a window.
olf the remote control is used in a cold place, ho'rizontallines or a
residual image may appear on the LCD screen. This is not a
malfunction. The LCD screen returns to normal when the remote
control warms up.