Honeywell T7560B Manual

HONEYWELL EXCEL 5000 OPEN SYSTEM
GENERAL
The T7560A,B Digital Wall Modules (DWM) display and
provide space temperature, setpoint, Occupied/Unoccupied
override, and fan mode/speed selection for the Honeywell
Excel 10 W7750, W7751, W7752, W7753, W7761, W7762,
W7763, and Excel 600, 500, 100, 50, 20 Controllers, as
applicable (a software module ModAL is available to adapt
the wall module to the respective Excel 20, 50, 100, 500, 600
controller. See T7560A,B,C Installation Instructions (product
literature no.: EN1B-0146GE51) for details.
Using the three buttons, the user can change room
temperature setpoint, fan mode/speed, initiate/cancel bypass,
and change configuration information such as the DWM's
engineering units.
The T7560C Digital Wall Module (see inset above) has no
user interface (e.g. LCD, buttons, or setpoint dial) and issues
only temperature and humidity values.
These wall modules are not compatible with Honeywell
W7751A,C,E,G (VAV1) and W7752D1 (FCU1) Controllers.
® U.S. Registered Trademark
Copyright © 2008 Honeywell Inc. • All Rights Reserved
T7560A,B,C Digital Wall Module
FEATURES
•
Fully compatible with all current Excel 10 and Excel
20 to 600 controllers.
•
Low power consumption.
•
Integral 20kΩ NTC sensor.
•
Separate mounting base for easy installation.
•
Tamper-resistant locking cover.
•
IP30 housing.
•
T7560A and B, only:
LCD display continuously shows current space
-
temperature, occupied/unoccupied/standby mode,
fan status/mode, humidity, as configured.
Push-button interface for full navigation and
-
change control of wall module functions.
Single-touch occupied/unoccupied override.
-
Setpoint dial for setpoint adjustment.
-
Fan Speed/Mode commandable from buttons.
-
Selectable °F/°C temperature display.
-
Selectable setpoint type, absolute or relative.
-
SPECIFICATION DATA
EN0B-0237GE51 R0208