Connection Of Stand-Alone Option Units - Mitsubishi Electric FR-F820-00046 Instruction Manual

2.8

Connection of stand-alone option units

The inverter accepts a variety of stand-alone option units as required.
Incorrect connection will cause inverter damage or accident. Connect and operate the option unit carefully in accordance with
the Instruction Manual of the corresponding option unit.
2.8.1 Connection of the brake unit (FR-BU2)
Connect the brake unit (FR-BU2(-H)) as follows to improve the braking capability during deceleration.
 Connection example with the GRZG type discharging resistor
Three-phase AC
power supply
*1 When wiring, make sure to match the terminal symbols (P/+, N/-) on the inverter and on the brake unit (FR-BU2). (Incorrect connection will
damage the inverter and brake unit.)
*2 When the power supply is 400 V class, install a stepdown transformer.
*3 The wiring distance between the inverter, brake unit (FR-BU2) and discharging resistor must be within 5 m. Even when the cable is twisted, the
wiring length must be within 10 m.
*4 It is recommended to install an external thermal relay to prevent overheat of the discharging resistor.
*5 For the connection method of the discharging resistor, refer to the Instruction Manual of the FR-BU2.
*6 Terminal P3 is equipped in the FR-F820-00770(18.5K) to 01250(30K) and the FR-F840-00470(22K) to 01800(75K). Terminal P3 has the same
function as terminal P\+ on the inverter.
• Recommended external thermal relay
Brake unit
FR-BU2-1.5K
FR-BU2-3.7K
FR-BU2-7.5K
FR-BU2-15K
FR-BU2-H7.5K
FR-BU2-H15K
FR-BU2-H30K
NOTE
• Set "1" in Pr.0 Brake mode selection in the FR-BU2 to use a GRZG type discharging resistor.
• Do not remove the jumper across terminals P/+ and P1 except when connecting a DC reactor (FR-HEL).
76
2. INSTALLATION AND WIRING
2.8 Connection of stand-alone option units
MCCB
MC
Discharging resistor
GZG 300W-50Ω (one)
GRZG 200-10Ω (three in series) TH-T25-3.6A
GRZG 300-5Ω (four in series)
GRZG 400-2Ω (six in series)
GRZG 200-10Ω (six in series)
GRZG 300-5Ω (eight in series)
GRZG 400-2Ω (twelve in series) TH-T25-11A
T ∗2
MC
Motor
U
R/L1
External thermal
S/L2 V
M
relay
W
T/L3
Inverter
∗3
P/+ (P3) ∗6
∗1
N/-
∗4
10 m or less
Recommended
external thermal relay
TH-T25-1.3A
TH-T25-6.6A
TH-T25-11A
TH-T25-3.6A
TH-T25-6.6A
To the brake
unit terminal P/+
ON OFF OCR contact
MC
GRZG type
∗5
discharging
OCR resistor
R R
∗4
FR-BU2
PR
A
P/+ B
∗1
N/- C
BUE
SD
1/L 5/L
1 3
2/T 6/T
1 3
To a resistor