Mitsubishi Electric FR-F820-00046 Instruction Manual page 158

 Selecting a parameter by function group number to change its setting
The following shows the procedure to change the setting of P.H400 (Pr.1) Maximum frequency.
Operating procedure
1.
Turning ON the power of the inverter
The operation panel is in the monitor mode.
2.
Changing the operation mode
Press to choose the PU operation mode. [PU] indicator turns ON.
3.
Selecting the parameter setting mode
Press to choose the parameter setting mode. (The parameter number read previously appears on the 12-
segment LCD display.)
4.
Enabling the function group selection
Press several times until "
5.
Enabling the function group selection
Turn until "
"
of Protective function parameter 4.
6.
Selecting a parameter
Turn until "
value. "
7.
Changing the setting value
Turn to change the set value to "
"
" (Protective function parameter 4) appears. Press
" will appear, which shows that the operation panel is ready for selection of a number in the group
" (P.H400 Maximum frequency) appears. Press
(initial value)" appears.
" are displayed alternately after the setting is completed.
" appears. Parameter groups can now be selected.
". Press to confirm the selection. "
to confirm the selection.
to display the present set
" and 10
157
5. PARAMETERS
5.1 Parameter list
1
2
3
4
5
6
7
8
9