Parameter List - Mitsubishi Electric FR-F820-00046 Instruction Manual

5
PARAMETERS
This chapter explains the function setting for use of this product.
Always read the instructions before use.
The following marks are used to indicate the controls. (Parameters without any mark are valid for all the controls.)
Mark
V/F V/F V/F
Magnetic flux Magnetic flux Magnetic flux
PM PM PM
The setting range and the initial value of parameters differ depending on the structure or functions of the inverter. The following
common designations are used for each type of the inverter models.
Inverter model
FR-F8[]0
FR-F8[]2
FR-F8[]6
5.1

Parameter list

5.1.1 Parameter list (by parameter number)
For simple variable-speed operation of the inverter, the initial values of the parameters may be used as they are. Set the
necessary parameters to meet the load and operational specifications. Parameter's setting, change and check can be made
on the operation panel (FR-DU08).
NOTE
Simple Simple Simple
•
only.
• The changing of the parameter settings may be restricted in some operating statuses. Use Pr.77 Parameter write selection
to change the setting of the restriction.
• Refer to
132
5. PARAMETERS
5.1 Parameter list
V/F control
Advanced magnetic flux vector control
PM motor control
Common designation
Standard model
Separated converter type
IP55 compatible model
indicates simple mode parameters. Use Pr.160 User group read selection to indicate the simple mode parameters
page 638 for instruction codes for communication and availability of Parameter clear, all clear, and Parameter copy.
Control method Applied motor
Three-phase induction motor
PM motor