Giving a start command from the operation panel
for JOG operation
• JOG operation is performed while
The following shows the procedure to operate at 5 Hz.
Turning ON the power of the inverter
The operation panel is in the monitor mode.
Changing the operation mode
Start → acceleration → constant speed
Jog acceleration/deceleration time, and "
Deceleration → stop
deceleration time. "
• To change the running frequency, change the setting of Pr.15 Jog frequency (initial value: 5 Hz).
• To change the acceleration/deceleration time, change the setting of Pr.16 Jog acceleration/deceleration time (initial value:
Parameters referred to
Pr.15 Jog frequency, Pr.16 Jog acceleration/deceleration
4. BASIC OPERATION
4.7 Basic operation procedure (JOG operation)
twice to choose the PUJOG operation mode. The display shows "
down to keep the JOG operation. The frequency increases according to the setting of Pr.16
. The frequency decreases according to the setting of Pr.16 Jog acceleration/
" (0.00 Hz) appears on the LCD display, and the motor stops rotating.
on the operation panel is pressed.
" (5.00 Hz) appears on the LCD display.
", and [PU] indicator is ON.