Changing The Frequency (60 Hz, Initial Value) At The Maximum Voltage Input (5 V, Initial Value) - Mitsubishi Electric FR-F820-00046 Instruction Manual

Fr-f800 series
Hide thumbs Also See for FR-F820-00046:
Table of Contents

Advertisement

4.6.4
Changing the frequency (60 Hz, initial value) at the
maximum voltage input (5 V, initial value)
• Change the maximum frequency.
The following shows the procedure to change the frequency at 5 V from 60 Hz (initial value) to 50 Hz using a frequency setting
potentiometer for 0 to 5 VDC input. Set 50 Hz in Pr.125 so that the inverter outputs 50 Hz at 5 V input.
Operating procedure
1.
Selecting the parameter
Turn
Press
2.
Changing the maximum frequency
Turn
Press
3.
Selecting the mode and the monitor item
Press
4.
Start
Turn ON the start switch (STF/STR signal), and turn the frequency setting potentiometer clockwise slowly to full.
(Refer to steps 2 and 3 in 4.6.3.)
The motor is operated at 50 Hz.
NOTE
• To change the frequency at the input of 0 V (minimum voltage), use the calibration parameter C2.
• Other adjustment methods for the frequency setting voltage gain are the following: adjustment by applying a voltage directly
across terminals 2 and 5, and adjustment using a specified point without applying a voltage across terminals 2 and 5. (Refer
to
page
Parameters referred to
Pr.125 Terminal 2 frequency setting gain
C2 (Pr.902) Terminal 2 frequency setting bias
C4 (Pr.903) Terminal 2 frequency setting
126
4. BASIC OPERATION
4.6 Basic operation procedure (External operation)
until "
" (Pr.125) appears.
to read the present set value. (60.00 Hz)
to change the set value to "
to confirm the selection. "
three times to select the monitor mode, and change the monitor item to the frequency.
60Hz
(50Hz)
Output frequency
(Hz)
Bias
C2
(Pr.902)
0
0
0
C3(Pr.902)
339.)
frequencypage 339
frequencypage 339
gainpage 339
". (50.00 Hz)
" and "
"are displayed alternately.
Initial value
100%
Frequency setting signal
Gain
Pr.125
5V
10V
C4(Pr.903)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents