Frequently-Used Parameters (Simple Mode Parameters) - Mitsubishi Electric FR-F820-00046 Instruction Manual

Fr-f800 series
Hide thumbs Also See for FR-F820-00046:
Table of Contents

Advertisement

4.4
Frequently-used parameters (simple mode
parameters)
Parameters that are frequently used for the FR-F800 series are grouped as simple mode parameters.
When Pr.160 User group read selection = "9999", only the simple mode parameters are displayed on the operation panel.
This section explains the simple mode parameters.
4.4.1
Simple mode parameter list
For simple variable-speed operation of the inverter, the initial values of the parameters may be used as they are. Set the
necessary parameters to meet the load and operational specifications. Parameter's setting, change and check can be made
on the operation panel (FR-DU08).
• Pr.160 User group read selection can narrow down the displayed parameters to only the simple mode parameters. Set
Pr.160 User group read selection as required. (To change the parameter setting, refer to
Pr.160 setting
9999 (FM type initial value)
0 (CA type initial value)
1
Pr.
Pr. group
0
G000
Torque boost
Maximum
1
H400
frequency
Minimum
2
H401
frequency
3
G001
Base frequency 0.01 Hz
Multi-speed
4
D301
setting (high
speed)
Multi-speed
5
D302
setting (middle
speed)
Multi-speed
6
D303
setting (low
speed)
Acceleration
7
F010
time
Deceleration
8
F011
time
Electronic
H000
9
thermal O/L
C103
relay
Operation mode
79
D000
selection
114
4. BASIC OPERATION

4.4 Frequently-used parameters (simple mode parameters)

Only simple mode parameters are displayed.
All parameters (simple mode parameters and extended parameters) are displayed.
Only parameters registered in user groups are displayed.
Initial value
Name
Increment
FM
*1
6%
*2
4%
*3
3%
0.1%
*4
2%
1.5%
*6
1%
120 Hz
0.01 Hz
60Hz
0.01 Hz
0 Hz
60 Hz
0.01 Hz
60 Hz
0.01 Hz
30 Hz
0.01 Hz
10 Hz
*9
5 s
0.1 s
*10
15 s
*9
10 s
0.1 s
*10
30s
*7
0.01 A
Inverter rated
current
*8
0.1A
1
0
Description
*11
Range
CA
Set this parameter to obtain a higher starting
torque under V/F control. Also set this when a
0 to 30%
loaded motor cannot be driven, the warning
"OL" occurs, and the inverter output is shut off
with the fault indication "E.OC1".
*5
*7
0 to 120Hz
Set the upper limit for the output frequency.
*8
0 to 120 Hz
Set the lower limit for the output frequency.
Set this parameter when the rated motor
50 Hz
0 to 590 Hz
frequency is 50 Hz. Check the rating plate of
the motor.
50 Hz
0 to 590 Hz
Pre-set the speeds that will be switched
0 to 590 Hz
among by terminals.
0 to 590 Hz
0 to 3600 s
Set the acceleration time.
0 to 3600 s
Set the deceleration time.
*7
0 to 500 A
Protects the motor from heat.
Set the rated motor current.
*8
0 to 3600A
Select the start and frequency command
0 to 4, 6, 7
sources.
page
110.)
Application
527
271
528
118,
123,
249
216
252
228
Refer
to
page

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents