Table of Contents
Advertisement
4
Introduction
This booklet describes the programmable parameters, and provides bar codes for programming the SpeechMike
Barcode.
Operational Parameters
The SpeechMike Barcode is shipped with the factory default settings shown in Table 1. These factory default
values are stored in non-volatile memory and are preserved even when the scanner is powered down.
To change the parameter values:
Scan the appropriate bar codes included in this chapter. The new values replace the existing memory values. The
factory default values can be recalled by scanning the RESTORE DEFAULTS bar code on page 7.
Table 1 lists the factory defaults for all parameters. To change any option, scan the appropriate bar code(s).
Table 1: Factory Default Table
Parameter
Set Factory Default
Beeper Volume
Beeper Tone
Beeper Frequency Adjustment
Beep After Good Decode
Transmit "No Read" Message
Parameter Scanning
Linear Code Type Security Levels
Bi-directional Redundancy
Bi-directional Redundancy
UPC/EAN
UPC-A
UPC-E
UPC-E1
EAN-8
EAN-13
Bookland EAN
Decode UPC/EAN Supplementals
Decode UPC/EAN Supplemental Redundancy
Revision: 2.0 , technical changes excepted
Advanced Scanner Configuration Guide
Factory Default
All Defaults
Medium
Medium Frequency
2500 Hz
Enable
Disable
Enable
1
Disable
Disable
Enable
Enable
Disable
Enable
Enable
Disable
Ignore
7
Advertisement
Table of Contents
