MadgeTech IFC200 Quick Installation Manual

USB Data Logger Interface
Quick Installation Guide

Package Contents

•
USB Interface Device
•
USB Cable
•
3.5mm Audio cable
•
Data Recorder Software
CD-ROM
•
Quick Installation Guide
Model No. IFC200 For Win 2000/XP
IMPORTANT: Do not connect the IFC200 to your PC
until instructed to do so or the setup will not work.
1

Set up USB Data Logger Interface

A
Insert the MadgeTech Data
Recorder Software CD-ROM into
your CD-ROM drive. The CD should
run automatically, and the CD
Contents screen should appear. If
it does not, click the Start button
and choose Run. A field will
appear, enter D:\autorun.exe (If
"D" is the letter of your CD-ROM
A
drive).
B
Click on the Install MadgeTech
2.00 link on the CD Contents
screen to start the installation of
the Data Recorder Software. A new
window will appear. Follow the on
screen prompts to complete the
software installation. See the
Software Manual or go online at
www.madgetech.com for
Additional Information.
B
C
To install the IFC200, click the

Install USB Interface Drivers

link on the CD Contents screen. A
new window will appear prompting
for a directory and to start the
installation.
By default, the directory is set to
be the default installation directory
for the Data Recorder Software. If
C
you choose to change the directory
where the drivers will be stored,
do so here by clicking Browse.
When the directory is set to the
correct location, click the Install
button to start the installation.
D
When using Windows XP, a screen
may appear indicating the software
has not passed Windows Logo
Testing. This software has been
D
tested and works properly with
Windows XP. Click the Continue
Anyway button to resume the
installation. When finished, a
message will display indicating the
installation was successful.
All the necessary drivers for the
IFC200 to work correctly should
now be pre-installed onto your PC.
Click the OK button to close the
Pre-Installer window. In the CD
D
Contents window, click the Exit
CD Browser link to exit the
autorun program.
2
Connect the USB Data Logger Interface
For Windows 2000
A
Warning:
Remove the Warning label to
Install driver before
expose the USB connector.
connecting this device.
Connect one end of the included
A
USB cable to the USB port of
the IFC200.
B
Connect the other end to a USB
port on your PC. When the
IFC200 is plugged in, the
B
Found New Hardware window
will display. Windows 2000 will
automatically install the proper
software drivers for the IFC200
as long as step one was
completed.
B
Allow the PC to complete the
installation. Once finished, the
Found New Hardware window
will disappear and the blue
power LED on the IFC200 will
B
light up. Once this occurs, you
can skip ahead to step three,
Test USB Interface Device
Operation.
For Windows XP
A
Warning:
Remove the Warning label to
Install driver before
expose the USB connector.
connecting this device.
Connect one end of the
A
included USB cable to the USB
port of the IFC200.