Ricoh Aficio SP 5100N User Manual page 60

5 Fasten the four screws supplied with your new hard disk.
6 Close the control board cover by aligning the groove on it with the
notch on the printer and sliding it.
7 Reinstall the duplex-slot cover or the duplex unit.
8 Reconnect the power cord and printer cable, and turn the printer
on.
9 Print a configuration page from the control panel to check if the
hard disk is correctly installed. See page 8.1.
Setting the hard disk in the printer properties
After installing the hard disk, you need to select it in the printer properties
to enable its use. Take the following steps:
1 Click the Windows Start menu.
2 For Windows 98/Me/NT 4.0/2000, select Settings and then
Printers.
For Windows XP/2003, select Printers and Faxes.
3 Select the SP 5100N PCL 6 printer icon or SP 5100N PS printer
icon.
4 Click the right mouse button on the printer icon and select
Properties.
5 In PCL 6 Properties, click the Printer tab and then check Optional
Hard Disk Drive (HDD).
In PS Properties, click the Device Option or Device Settings tab
and set the Optional Hard Disk Drive (HDD) option to Installed.
6 Click OK.
10.4
<Installing accessories>