Download Print this page
FujiFilm FCR PRIMA T2 Quick Manual
Hide thumbs Also See for FCR PRIMA T2:

Advertisement

Quick Links

Power ON/OFF
Power ON
1
2
3
CAUTION
Leave 10 cm (4 in.) or more space at both sides
of the Image Reader to allow the cooling fans
inside to intake and exhaust air.
10 cm (4 in.)
or more
Power OFF
1
3
4
897N102548
Power ON
The monitor lamp changes from
orange to blue.
Power ON
After the Console (PC) has
booted, an application starts.
Power ON
Equipment initialization starts.
10 cm (4 in.)
or more
Click
When
is clicked, the
confirmation window is shown.
2
Click
Confirm that "Shut-
down the PC" is se-
lected and click [OK].
Check
When the Console (PC) shuts
down, the power supply is
switched off automatically.
To switch off the power
independently, press the
(Stand-by Switch) for
approximately 4 seconds.
Power OFF
Turn off the Main Power Switch.
FCR PRIMA T2 (CR-IR 392)
X-ray Exposure
Registration of patient information
1
Select Exposure menu
1
X-ray exposure and image confirmation
1
2
3
4
Quick Guide
Register
Register Patient ID,
Patient Name, Sex,
and Date of Birth.
Click
when
the input of patient
information has been
completed.
Select
Select the Exposure
menu.
The Read Image
window is displayed
automatically.
X-ray Exposure
Image Reading
• Slowly insert the cas-
sette straight along
the guide at the right.
• Before inserting the
cassette, remove
the exposure marker
from the cassette.
Check
Start the Image Viewer
window and confirm
the image.
Click
When this is clicked,
the display returns to
the Main window.
When a printer is
connected, the image
is put out to film.
1

Advertisement

loading

Summary of Contents for FujiFilm FCR PRIMA T2

  • Page 1 FCR PRIMA T2 (CR-IR 392) Quick Guide Power ON/OFF X-ray Exposure Power ON Registration of patient information Power ON Register The monitor lamp changes from Register Patient ID, orange to blue. Patient Name, Sex, and Date of Birth. Power ON...
  • Page 2 Frequent messages and countermeasures is displayed. / Images are not transferred. Countermeasures Stop the buzzer. Press (Stand-by Switch) to stop the buzzer. Press ►Cause (Stand-by Switch) again to clear the error indication. - The read image data could not be transferred to the Remove the cassette slowly.
  • Page 3 Frequent messages and countermeasures Scanner Cleaning Image erasing is not completed. Lines can be seen on the read image. ►Cause The IP has been returned to the cassette without completion of erasing the images exposed to the IP. CAUTION Line - Erase the image(s) on the IP 16 or more hours later after is displayed.
  • Page 4 Table of error numbers HINT CAUTION - When an error occurs, jot down the error code and - When an error requiring restart occurs, all perform error cancellation. lamps blink and an error No. is displayed. Jot down the error No. and restart the device. - An error may be resolved after turning off the main If the error occurs again after restart, contact power for a while and turn it on again.

This manual is also suitable for:

Cr-ir 392