What to Do If an Error Occurs
7.1 What to Do If an Error Occurs (Analog Input)
7.1.1 Failure in Reading Analog Input Data
• Check again that I/O allocations are correct.
• Check again the connections of the terminal block.
• Check again the configuration settings.
7.1.2 Unstable Analog Input Conversion Value
• Used a twisted pair shield wire and check that the wire is properly shielded.
• Check that the analog input wiring is not placed close to AC lines or high-tension lines or
bundled with the lines.
• Check that there are no power lines, high-tension lines, high-capacity relays, or noise-
generating equipment, such as inverters, close to the analog input unit.
7.1.3 No Proper Conversion Values Obtained with Current Input
• Check again the connections of the terminal block.
• Check again the connections of the output equipment.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
7-2