Advertisement
Quick Links
&KIKVCN"#PUYGTKPI"5[UVGO
43-3808A
OWNER'S MANUAL — Please read before using this equipment.
#
#
"+/2146#06"
If an icon appears at the
end of a paragraph, go
to the side head box on
that page with the
corresponding icon for
pertinent information.
Rý
— Signifies a
Warning
. . . .
— Signifies a
Caution
#
— Signifies Important
text
%106'065
The FCC Wants You
to Know .................... 3
Features ................... 4
Preparation ............... 6
Operation ................ 11
Remote Operation .. 17
Care ....................... 19
Service and Repair . 19
4'#&"6*+5"$'(14'"
+056#..#6+10
Your Digital Answering System is ETL
listed to UL standards and meets all
applicable FCC requirements.
WARNING:
To reduce the risk the of fire or
shock hazard, do not expose this product to rain or
moisture.
..
..
CAUTION
RISK OF ELECTRIC
SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELEC-
TRIC SHOCK, DO NOT REMOVE COVER OR
BACK. NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED PERSONNEL.
The lightning symbol is intended to alert you
to the presence of uninsulated dangerous
voltage within this product's enclosure that
might be of sufficient magnitude to consti-
tute a risk of electric shock. Do not open the
product's case.
The exclamation symbol is intended to in-
form you that important operating and
!
maintenance instructions are included in
the literature accompanying this product.
(%%"56#6'/'06
Your answering system complies with
Part 68 of FCC Rules . You must, upon
request, provide the FCC registration
number and the REN to your telephone
company. Both numbers are on the
bottom of your system.
© 2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks used
by RadioShack Corporation.
!
Advertisement
Related Manuals for Radio Shack 43-3808A
Summary of Contents for Radio Shack 43-3808A
- Page 1 &KIKVCN"#PUYGTKPI"5[UVGO 43-3808A OWNER’S MANUAL — Please read before using this equipment. 4'#&"6*+5"$'(14'" "+/2146#06" +056#..#6+10 If an icon appears at the end of a paragraph, go Your Digital Answering System is ETL to the side head box on listed to UL standards and meets all that page with the applicable FCC requirements.
- Page 2 We have designed your answering ± ± "016'" " system to conform to federal regulations, and you can connect it to You must not connect most telephone lines. However, each your answering system answering system (and each device, such as a telephone or answering •...
- Page 3 affect the operation of this telephone. The telephone company notifies you of these changes in advance, so you can take the necessary steps to prevent interruption of your telephone service. 6*'"(%%"9#065";17" 61"-019 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules .
- Page 4 • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult your local RadioShack store or an experienced radio/TV technician for help.
- Page 5 system is fully digital, there are no tape mechanisms to wear out and no tapes to bother with. Day/Time Stamp — records the day and time each message was recorded. Call Screening — lets you listen to incoming calls so you can decide whether or not to answer a call.
- Page 6 24'2#4#6+10 056#..+0) #66'4; If AC power fails or you unplug the system, one 9V alkaline battery (not supplied) is needed to save any re- corded messages and the settings for the day and time. For the best performance and longest life, we recommend you use a RadioShack alkaline battery.
- Page 7 standard AC outlet. The display lights 9h 9h 9h 9h appears. The system initializes in about 20 && && && && seconds, then sounds 4 tones. ## ## ## ## alternately appear. If you did not Be Be Be Be &&...
- Page 8 740+0) To turn on the system, press . The display lights and the STOP system sounds a tone. The system is set to answer calls. To turn it off, press display turns off and the system sounds 2 tones. &,756+0) Push down or pull up to increase or decrease the volume.
- Page 9 3. While holding down SKIP/TIME press SET/CHECK, MEMO/2 WAY/ . The system announces “1 HOUR &' &' &' &' AM”. appears on the display. Repeatedly press MEMO/2 WAY/ until you hear or see the HOUR correct hour. 4. While holding down SKIP/TIME press SET/CHECK,...
- Page 10 messages, the system answers after two rings. Otherwise, the system answers after four rings. This lets you avoid unnecessary charges when calling by long distance to check your messages. If you hear more than two rings, you know you can hang up because the system has no new messages.
- Page 11 1. Hold down REPEAT/ANNC/DAY flashes on the display, and the system sounds a tone. 2. Speak your message clearly into the microphone from about 10 inches away from the system. 3. Release when REPEAT/ANNC/DAY you finish your message. The system sounds a tone and automatically plays back your 7' 7' 7' 7' recorded message.
- Page 12 than 7 seconds, or the maximum message length is reached, the system hangs up and resets to answer the next call. The number flashes to indicate a new incoming message has been recorded. When the system is answering a call or recording a message, if any phone on the same line is picked up or the system detects a Calling Party Control...
- Page 13 messages (see “Deleting Messages” on Page 17). If memory is full, the system announces “Memory is full” when you record an outgoing message or memo. "# " 5+0) 00170%' Your system’s announce-only feature lets you set the system to play a message for the caller, then automatically hang up without letting the caller leave a message.
- Page 14 When the system is set for announce- ± ± "016'5" " only, you cannot set it to record incoming messages using the remote • If you pick up the commands. phone just as the system answers, To turn off the announce-only feature the system might so callers can leave messages, slide not stop playing the...
- Page 15 3. When you finish speaking, release . The system MEMO/2 WAY/HOUR sounds a tone. The number flashes on the display until you play the memo. " "6 '%14&+0) "% *10' 108'45#6+10 You can record both sides of a conversation on any phone connected to the same phone line as the system.
- Page 16 To listen to messages , press PAUSE/MIN new message and the sequence number appears. The system announces the day and time the message was recorded. After you play all the new messages, the display shows the total number of recorded messages, and the system automatically saves the messages and resets to answer calls.
- Page 17 & "/ '.'6+0) '55#)'5 You can delete messages individually during playback, or all at once after playback. To delete a particular incoming message, memo, or two-way phone conversation (after listening to it), press during playback. DELETE To delete all messages after playback, hold down for about 3 DELETE...
- Page 18 bottom of the system. Enter the security code after the system answers and sounds two tones. Within 7 seconds, enter one of the remote commands. 2'4#6+0) (41/ Dial your phone number. Even if the system is off, it will turn on and answer after about 10 rings.
- Page 19 %#4' If the system gets wet, wipe it dry immediately. Use and store the system only in normal temperature environments. Do not drop it. Keep the system away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new.
- Page 20 This product is warranted by RadioShack against manufacturing de- fects in material and workmanship under normal use for one (1) year from the date of purchase from RadioShack company-owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WAR- RANTIES AND ANY IMPLIED WARRANTIES, INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE DURATION OF...