Honda GL1100 1980 Owner's Manual page 11

Hide thumbs Also See for GL1100 1980:
Table of Contents

Advertisement

Check the tires for cuts, imbedded nails
or other sharp objects. Check the rims
for dents or deformation.
If
there is any
damage, see your authorized Honda dealer
for repair, replacement, and balancing.
11£Q.1;I~i!UiJ
*
Improper tire inflation will cause ab-
normal tread wear and create a safety
hazard. tlnderinflation may result in
the tire slipping on, or coming off of
the rim.
*
Operation with excessively worn tires
is hazardous and will adversely affect
traction and handling.
Replace tires before tread depth at the
center of the tire reaches the following
limit:
Minimum tread depth
Front:
1.5 mm 0/16 in)
Rear:
2.0 mm (3/32 in)
6
Repair/Replacement;
See your authorized Honda Dealer
f?t
b
·i;PiiU1
*
The use of tires other than those listed
on the tire information label may
adversely affect handling.
.
*
Do not install tube-type tires on tube-
less rims. The beads may not seat and
the tires could slip on the rims, causing
tire deflation.
*
Proper wheel balance is necessary for
safe, stable handling of the motor-
cycle. Do not remove or change any
wheel balance weights. When wheel
balancing is required, see your author-
ized Honda dealer. Wheel balancing is
required after tire repair or replace-
ment.
*
Do not exceed 50 mph for the first 24
hours. after tire repair, or repair failure
and tire deflation may result. Never use
a repaired tire at speeds over 80 mph.
*
Replace the tire if the sidewall is
punctured or damaged. Sidewall flex-
ing may cause repair failure and tire
deflation.

Advertisement

Table of Contents
loading

Table of Contents