Advertisement
LMW – Trade Line Owner's Manual
If your bath has a whirlpool system, simply pushing the push-button located on the tub will turn the tub on or
off. Individual jets may be adjusted by turning the jet ring/trim clockwise and the water flow will increase,
while turning the jet trim counterclockwise will decrease the water flow. The jets can be closed if turned far
enough counterclockwise. The 6 jet system has a 1 ½ hp pump and requires a 20 amp dedicated circuit, 120V.
Operation- Push the button located on the tub to turn the tub on or off. The tub operates at one speed.
Manual Purge Cycle – Once the tub is drained, wait 20 then press the ON button. Let the system run for 30
seconds to dry any remaining water in the air nozzles. The purge cycle is optional.
Functioning
1) 14 lateral turbo air injectors spaced around the lower side walls of the tub.
2) The system functions with a 1 hp blower / 300W ceramic heater that is separate from any other systems.
3) This system requires a 20 Amp dedicated circuit, 120V.
4) The ceramic air heater is designed to provide a warm air massage. It is not designed to heat the bath water.
Whirlpool Inline Heater - The inline heater is designed to MAINTAIN the temperature of the tub between 101-
104 degrees Fahrenheit. These limits cannot be increased or decreased. The Heater is operated by a pressure
switch which is programmed into the heater. This switch allows the heater to operate only when there is
sufficient water flowing through the system. DO NOT BYPASS THE SWITCH. This option is equipped with a
molded plug on the end of a supply cord. Check your local codes and install a 120VAC 20amp GFCI protected
dedicated circuit wall outlet within 1.5' from the heater unit. Plug the cord into the outlet. Every time the
whirlpool unit is activated, the heater will activate as well, and will MAINTAIN the water's temperature
between 101-104 F.
Water Heater for Air Bath and Soaker Tubs - The on/off button on the bath tub activates/deactivates the
heater. The heater has a built-in 20 minute timer and is a low flow/high efficiency pump, providing silent
operation. The option is equipped with a molded plug on the end of a power supply cord. Check your local
codes. For the LM305 install a 120 VAC 15amp GFCI, and for the LM306, install a 250 VAC 25amp GFCI. Both
water heaters should have a GFCI protected dedicated circuit wall outlet located within 1.5' from the heater
unit. Plug the cord into the outlet. This heater is designed to MAINTAIN the temperature in your tub between
101-104 deg Fahrenheit. These temperatures are preset and cannot be adjusted.
Ozonator - This factory installed option sanitizes your whirlpool. When your whirlpool system is operating
your ozonator is generating ozone which is mixed with the re-circulating bath water. The ozone helps
neutralize soaps, body oils and other organic and inorganic materials. This unit eliminates the need to run a
sanitation solution through the tub's circulating system.
Chromotherapy Mood Light - The ColorGlo LED Multi-Color bath light comes pre-programmed with 10 light
modes. To change modes, switch the unit off and then back on within 5 seconds. To resume a lighting mode,
leave the unit switched off to save the last lighting mode displayed in memory. That same lighting mode will
display the next time the unit is switched on.
Advertisement
