Cisco GS7000 Installation And Configuration Manual page 45

To Remotely Upgrade the Software
Complete the following steps to remotely download and upgrade the application
software image in the Hub Node or Optical Hub.
1 Launch the HMS Download Tool. The main screen appears as shown below.
Note: The field settings shown above are typical values for the LCM.
2 Click the Browse button to select the new software image.
3 Change the Device Key to GS7000.
4 Set the Address Type to Unicast.
5 Enter the Transponder IP address.
6 Enter the Phoenix IP address (optional).
7 Set the SNMP Commands Timeout to 25 (seconds).
8 Choose Startup and Reset from the Download Option drop-down menu.
9 Enter the appropriate Download Device number based on the corresponding
physical slot number of the download device. Use 1 for Transponder, 7 for LCM,
or 3 to 11 for each EDFA or OPSW physical slot number.
10 Set the Download Image to 2 for LCM, EDFA, and OPSW. The Transponder is
set by the tool after the correct transponder image file, APP1 or APP2, is selected
via the Browse button.
OL-29937-01
Status Monitor Configuration Procedure
31