TP-Link TL-WPA4220 Quick Installation Manual

LED Indicators
Power
On: The device is on.
O : The device is o .
Blinking: The device is pairing.
Powerline
On: The device is connected to a powerline network.
O : The device isn't connected to any powerline network.
Blinking: The device is transferring data.
Ethernet
On: At least one Ethernet port is connected.
O : No Ethernet port is connected.
Wi-Fi
O : The wireless function is disabled.
Quick Installation Guide
Blinking quickly: The wireless function is enabled.
Blinking every second: The device is cloning Wi-Fi settings from
a router.
AV500
Wi-Fi/Wi-Fi Clone
WiFi Powerline Extender/Starter Kit Button
A powerline network requires at least two powerline
devices. We use the powerline adapter TL-PA4010 as an
example to work with TL-WPA4220.
Note
If your home or o ce already has powerline adapters,
remove them rst, install TL-WPA4220 using Method 1
or Method 2, and then add your existing adapters to the
powerline network.
For non-passthrough powerline device
AV500
For passthrough powerline device
AV500
Pair Reset Ethernet
Button Button Ports
Method 1: Plug and Play
Create a New Wireless Network
1.
Write down the default wireless network name
(SSID) and password of TL-WPA4220.
AV500 Wireless Network
Name (SSID)*:
TP-LINK_XXXXXX
Wireless Password:
XXXXXXXX
* The default SSID is TP-LINK_XXXXXX. (XXXXXX indicates the last six unique
characters of the WLAN MAC address.)
2.
Read this to install additional devices
Connect your devices as follows.
1. Make sure the additional devices use factory default settings. If not,
please reset them.
SSID:
ABCDE 2. Plug them into the outlets and wait about 1 minute until their
Internet
Powerline LEDs turn solid.
TL-PA4010
LAN WAN
TL-PA4010
All the Powerline LEDs will turn
solid within 1 minute.
Installation is completed when all the
SSID:
Powerline LEDs turn solid.
TP-LINK_XXXXXX
If the Powerline LEDs do not turn solid, please follow the instructions in
TL-WPA4220
AV500
FAQ->Q1:
1. For the two devices connected before, use the Pair Button to create a
powerline network (Q1->A). (Skip this step if you have already done this.)
2. For additional devices, use the Pair Button to join the existing powerline
network (Q1->B).
Enjoy!
Use the default SSID
(TP-LINK_XXXXXX) and
password you wrote down
to access the Internet.
If the Powerline LEDs don't turn solid, reset all the powerline devices, or create
a powerline network by referring to FAQ-Q1.
AV500 AV500
TL-WPA4220 TL-WPA4220 Additional
Device
7106504781 REV3.0.0