TP-Link TL-WR810N Quick Installation Manual

Quick
Installation Guide
300Mbps Wi-Fi Pocket Router/AP/
TV Adapter/Repeater
*TL-WR810N (European version) is used
for demonstration in this QIG.
Standard Wireless Router
Internet
C

Access Point

Internet
C
Wired Router
Determine Operation Mode
Install the plug and determine the operation mode of the router as you need.
N
1 0
R 8
L -W
s T
b p
0 M
3 0
Mode Switch
A
30
0M
bp
s TL
-W
R 81
0N
B
LAN/WAN LAN
A
30
0M
bp s TL
-W
R 81
0N
B
LAN/WAN
Operation Modes Application
Standard Wireless Router To share a wired (Ethernet) connection to wireless devices, when in a
hotel room, small office, etc.
Access Point To transform an existing wired (Ethernet) network to a wireless one.
Repeater To extend the range of an existing Wi-Fi network.
Client To function as a wireless adapter to connect your wired device (e.g.
Blu-ray® players, smart TVs, or game consoles) to a Wi-Fi network.
1 Switch the Operation Mode to Router/AP and connect the hardware
according to step A to C in the left diagram.
2 Connect your device to the router wirelessly or via an Ethernet cable.
The Wi-Fi network name and password are on the router's label.
3 Launch a web browser and type http://tplinkwifi.net in the address
bar. Enter admin (in lowercase) for both username and password to
log in.
4 Click Next to start the Quick Setup. Select Standard Wireless Router
mode and click Next.
OR 5 Select the WAN Connection Type and follow the instructions. When
using the router in a hotel room or a small office, select Dynamic IP.
Note: If the router is successfully connected to the Internet, this step
will be skipped.
6 On the Wireless page, either customize your Wireless Network Name
and Wireless Password or keep the default ones , and then click Next.
7 Click Finish to complete the configuration.
1 Switch the Operation Mode to Router/AP and connect the hardware
according to step A to C in the left diagram.
2 Connect your device to the router wirelessly or via an Ethernet cable.
The Wi-Fi network name and password are on the router's label.
3 Launch a web browser and type http://tplinkwifi.net in the address
bar. Enter admin (in lowercase) for both username and password to
log in.
4 Click Next to start the Quick Setup. Select Access Point mode and click
Next.
5 Either customize your Wireless Network Name and Wireless
Password or keep the default ones, and then click Next.
6 Select the LAN IP type of the router or leave the default setting Smart
IP for most cases, and then click Next.
7 Click Reboot to complete the configuration.