Table of Contents
Advertisement
≥ 18 kg (39.7 lb)
CAUTION:
Use safe practices when lifting.
Step 4.
Slide the blade server into the blade bay until it stops.
Step 5.
Push the release handles on the front of the blade server to the closed position.
Note: After the blade server is installed, the service processor in the blade server initializes and
synchronizes with the management module. This process takes approximately two minutes to
complete. The power-on LED flashes rapidly, and the power-control button on the blade server
does not respond until this process is complete.
Step 6.
Turn on the blade server (see "Turning on the blade server" on page 13 for instructions).
Step 7.
Make sure that the power-on LED on the blade server control panel is lit continuously, indicating
that the blade server is receiving power and is turned on.
Step 8.
If you have other blade servers to install, do so now.
Step 9.
Write identifying information on one of the labels that come with the blade servers and place
the label on the BladeCenter unit bezel. See the documentation for your BladeCenter unit for
information about the label placement.
Important: Do not place the label on the blade server or in any way block the ventilation holes
on the blade server.
Step 10. Reinstall the bezel assembly on the BladeCenter T unit (BladeCenter T unit only). For detailed
instructions for reinstalling the bezel assembly, see the Installation and User's Guide that comes
with the BladeCenter T unit.
If this is the initial installation of the blade server in the BladeCenter unit, you must configure the blade server
through the Setup utility and install the blade server operating system. See "Updating the blade server
configuration" on page 50 and Chapter 5 "Installing the operating system" on page 65 for details.
If you have changed the configuration of the blade server or if you are installing a different blade server from
the one that you removed, you must configure the blade server through the Setup utility, and you might have
to install the blade server operating system. For more information, see "Using the Setup utility" on page 53.
Updating the blade server configuration
Use this information to update the blade server configuration.
When the blade server starts for the first time after you add or remove an internal device, you might receive a
message that the configuration has changed. The Setup utility automatically starts so that you can save
the new configuration settings. See "Using the Setup utility" on page 53 for more information about the
Setup utility.
Some options have device drivers that you must install. See the documentation that comes with each
device for information about installing device drivers.
50
BladeCenter HS22 Blade ServerInstallation and User's Guide
≥ 32 kg (70.5 lb)
≥ 55 kg (121.2 lb)
Advertisement
Table of Contents
